Progressive-international-electronics PIcon Console Bedienungsanleitung PDF herunterladen (Seite 24)

PIcon Program & Report

Rev 2.0 June 2006

Page 20

Hose Selection — After the dispenser number is chosen, Hose 1 is indicated on the

display. From this point, the following parameters may be set for Hose 1. If

programming a multi-product dispenser, parameters must be set for all hoses.

• Product — Press the <GRADE> key to scroll to the desired product for the current

hose displayed. During this step, pressing the <AUTHORIZE> key will clear the

product number for reentry.

• Service — To select service type, press the <CHNG> key to toggle between full-

or self-service for the specified dispenser. Setting service type on one hose selects

it for the entire dispenser.

• Blend — If the dispenser is a blending dispenser, on the numeric keypad enter the

amount, in percent of hose 1, to be dispensed by the selected hose. Press

<ENTER>. (Default is set at 0.) Remember that any data entered on the numeric

keypad will appear on the display.

• Slowdown Amount — To set slowdown amount, enter new value on the numeric

keypad. Press <PUMP STOP>. Setting slowdown amount on one hose sets it for

the entire dispenser. Default is 15 cents. Maximum is 99 cents.

If the dispenser is a multi-product dispenser, press <SELECT> to scroll to the next hose to

be programmed. Follow this procedure to program each hose of each dispenser at the site.

To exit Mode 1, press the <MNGR> key. The PIcon display returns to M 0, the mode entry

prompt. To exit programming mode completely, press the <MNGR> key again. The PIcon

will return to operator mode.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 36 37

Keine Kommentare

Progressive-international-electronics PIcon Console Bedienungsanleitung Seite 24